4/4/2023 0 Comments Lightburn softwareThe Inkscape-generated gcode works perfectly fine. LightBurn-generated gcode (controlled by LightBurn): Inkscape-generated gcode (controlled by CNCjs): In their implementation, M4 is used to enable the laser and then G0 is used to actually turn the laser OFF and G1 is used to turn the laser ON during cutting. Apparently LightBurn is supporting >= GRBL 1.1e (which it looks like our boards firmware uses based on the github repo - v1.1e). ![]() the laser did not turn off during travel moves). What's the trick to get the LightBurn software working properly with our boards? I tried it out tonight and the laser was kept on the entire time the design was cut (i.e. ![]() ![]() Quote from sgraber on February 17, 2018, 4:02 am
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |